The Performance Evaluation of Viscous-Modified Surfactant Water Flooding in Heavy Oil Reservoirs at Varying Salinity of Injected Polymer-Contained Surfactant Solution

Document Type : Research Article


1 Department of Chemical and Petroleum Engineering, Schulich School of Engineering, University of Calgary, Calgary, AB, CANADA

2 Petroleum Research Center, Petroleum University of Technology, Tehran, I.R. IRAN


This study examines the effects of change in the concentrations of monovalent and divalent ions in the polymer-contained surfactant solution on the macroscopic behavior of viscous-modified surfactant waterflooding in heavy oil reservoirs. Salts that are used in this set of floods were sodium chloride, magnesium chloride, and calcium chloride. The results indicate that four different ranges of salinity (in terms of CaCl2 concentration) exist. Each of these ranges renders a unique behavior regarding the ultimate oil recovery trends. There exists a range of salinity in which the ultimate oil recovery does not change with the salinity increase. The second salinity range is beyond the salt tolerance (i.e., first salinity range) of the polymer-contained surfactant solution, which results in a decrease in the ultimate oil recovery. In the third range of salinity, ultimate oil recovery is enhanced due to the plugging of high-permeable pores. In the fourth salinity range, precipitation increases as the salinity increases and more pore throats (even some pores with intermediate permeability) are plugged and, thus, the ultimate oil recovery decreases.  


Main Subjects

[1] Yadali Jamaloei B., Insight Into the Chemistry of Surfactant-Based Enhanced Oil Recovery Processes. Recent Patents Chem. Eng., 2(1), p. 1 (2009).
[2] Yadali Jamaloei,B., "Experimental Study of Surfactant/Water/Polymer Flooding Using One-Quarter Five-Spot Glass Micromodels", M.Sc. thesis. Petroleum University of Technology, Tehran, Iran (2007).
[3] Yadali Jamaloei B., Kharrat R., Torabi F., Analysis and Correlations of Viscous Fingering in Low-Tension Polymer Flooding in Heavy Oil Reservoirs, Energy & Fuels, 24(12), p. 6384 (2010).
[4] Yadali Jamaloei B., Kharrat R., Fundamental Study of Pore Morphology Effect in Low Tension Polymer Flooding or Polymer-Assisted Dilute Surfactant Flooding, Transp. Porous Media., 76, p. 199 (2009).
[5] Yadali Jamaloei B., Kharrat R., Analysis of Microscopic Displacement Mechanisms of Dilute Surfactant Flooding in Oil-Wet and Water-Wet Porous Media, Transp. Porous Media, 81(1), p. 1 (2010).
[6] Yadali Jamaloei B., Kharrat R., Analysis of Pore-Level Phenomena of Dilute Surfactant Flooding in the Presence and Absence of Connate Water Saturation, J. Porous Media, 13(8), p. 671 (2010).
[7] Yadali Jamaloei B., Kharrat R., The Influence of Pore Geometry on Flow Instability and Microscale Displacement Mechanisms of Dilute Surfactant Flooding in Mixed-Wet Porous Media, J. Porous Media, 14(2), p. 91 (2011)
[8] Yadali Jamaloei B., Ahmadloo F., Kharrat R., The Effect of Pore Throat Size and Injection Flowrate on the Determination and Sensitivity of Different Capillary Number Values at High-Capillary-Number Flow in Porous Media, Fluid Dyn. Res., 42(5), 055505 (2010).
[9] Yadali Jamaloei B., Asghari K., Kharrat R., Ahmadloo F., Pore-Scale Two-Phase Filtration in Imbibition Process Through Porous Media at High- and Low-Interfacial Tension Flow Conditions, J. Petrol. Sci. Eng., 72(3-4), p. 251 (2010).
[10] Yadali Jamaloei B., Kharrat R., Asghari K., Pore-Scale Events in Drainage Process Through Porous Media Under High- and Low-Interfacial Tension Flow Conditions, J. Petrol. Sci. Eng., 75(1-2), p. 223 (2010).
[11] Yadali Jamaloei B., Kharrat R., Ahmadloo F., Selection of Proper Criteria in Flow Behavior Characterization of Low Tension Polymer Flooding in Heavy Oil Reservoirs, SPE Kuwait International Petroleum Conference and Exhibition, Kuwait City, Kuwait (2009).
[12] Bansal V.K., Shah D.O., The Effect of Divalent Cations (Ca 2+ and Mg 2+) on the Optimal Salinity and Salt Tolerance of Petroleum Sulfonate and Ethoxylated Sulfonate Mixtures in Relation to Improved Oil Recovery, J. Am. Oil Chem. Soc., 55(3), p. 367 (1978).
[13] Bansal V.K., Shah D.O., The Effect of Addition of Ethoxylated Sulfonate on Salt Tolerance, Optimal Salinity, and Impedence Characteristics of Petroleum Sulfonate Solutions, J. Colloid Interface Sci., 65(3), p. 451 (1978).
[14] Glover C.J., Puerto M.C., Maerker J.M., Sandvik E.L., Surfactant Phase Behavior and Retention in Porous media, Soc. Petrol. Eng. J., 19(3), p. 183 (1979).
[15] Gupta S.P., Trushenski S.P., Micellar Flooding-Compositional Effects on Oil Displacement, Soc. Petrol. Eng. J., 19(2), p. 116 (1979).
[16] Hirasaki G.J., Application of the Theory of Multicomponent, Multiphase Displacement to Three-Component, Two-Phase Surfactant Flooding. Soc. Petrol. Eng. J., 21(2), p. 191 (1981).
[17] Celik M.S., Manev E.D., Somasundaran P., Sulfonate Precipitation-Redissolution-Reprecipitation in Inorganic Electrolytes. In: Interfacial Phenomena in Enhanced Oil Recovery, AIChE Symposium, 212(78), p. 86 (1982).
[18] Hirasaki G.J., Lawson J.B., An Electrostatic Approach to the Association of Sodium and Calcium with Surfactant Micelles, Soc. Petrol. Eng. Reservoir Eng., 1(2), p. 119 (1986).
[19] Nelson R.C., The Salinity Requirement Diagram-a Useful Tool in Chemical Flooding Research and Development, Soc. Petrol. Eng. J., 22(2), p. 259 (1982).
[20] Kumar A., Neale G.H., Hornof V., Effects of Connate Water Composition on Interfacial Tension Behavior of Surfactant Solutions, J. Can. Petrol. Tech., 23(1), p. 37 (1984).
[21] Kumar A., Neale G., Hornof V., Effects of Connate Water Ionic Composition on Coalescence of Oil Droplets in Surfactant Solutions, J. Colloid Interface Sci., 104(1), p. 130 (1985).
[22] Maerker J.M., Gale W.W., Surfactant Flood Process Design for Loudon, Soc. Petrol. Eng. Reservoir Eng., 7(1), p. 36 (1992).
[23] Novosad J., Surfactant Retention in Berea Sandstone-Effects of Phase Behavior and Temperature, Soc. Petrol. Eng. J., 22(6), p. 962 (1982).
[24] Krumrine P.H., Falcone Jr., J.S., Campbell T.C., Surfactant Flooding 1: the Effect of Alkaline Additives on IFT, Surfactant Adsorption, and Recovery Efficiency, Soc. Petrol. Eng. J., 22(4), p. 503 (1982).
[25] Dullien F.A.L., "Porous Media: Fluid Transport and Porous Structure", Academic Press, San Diego, CA (1992).
[26] Zhong L., Mayer A., Glass R.J., Visualization of Surfactant-Enhanced Non-Aqueous Phase Liquid Mobilization and Solubilization in a Two Dimensional Micromodel, Water Resour. Res., 37(3), p. 523 (2001).
[27] Morrow N.R., The Effects of Surface Roughness on Contact Angle with Special Reference to Petroleum Recovery., J. Can. Petrol. Tech., 14(4), p. 42 (1975).
[28] Anderson W.G., Wettability Literature Survey-Part 2: Wettability Measurement, J. Petrol. Tech., 38(11), p. 1246 (1986).
[29] Chatzis I., Kuntamukkula M.S., Morrow N.R., Effect of Capillary Number on the Microstructure of Residual Oil in Strongly Water-Wet Sandstones, Soc. Petrol. Eng. Reservoir Eng., 3(3), p. 902 (1988).
[30] Friedmann F., Surfactant and Polymer Losses During Flow Through Porous Media, Soc. Petrol. Eng. Reservoir Eng., 1(3), p. 261 (1986).
[31] Thibodeau L., Neale G.H., Effects of Connate Water on Chemical Flooding Processes in Porous Media, J. Petrol. Sci. Eng., 19(3-4), p. 159 (1998).
[32] Emami Meybodi H., Kharrat R., Ghazanfari M.H., Effect of Heterogeneity of Layered Reservoirs on Polymer Flooding: an Experimental Approach Using Five-spot Glass Micromodel, EUROPEC/EAGE Conference and Exhibition, Rome, Italy (2008).