Using Microwave Radiation to Recover Granular Activated Carbon Exposed to Toluene Vapor

Document Type : Research Article

Authors

Department of Environmental and Occupational Health, Faculty of Medical Sciences, Tarbiat Modares University, P.O. Box 14115-331 Tehran, I.R. IRAN

Abstract

This paper describes laboratory scale experiments examining the impact of microwave irradiation on the Granular Activated Carbon (GAC) exposed to toluene, a common organic vapor frequently released into work environment as well as outdoor. A stream containing 300 ppm toluene was supplied and passed through the granular activated carbon. The saturated adsorbent was placed in a quartz glass reactor and treated by microwave irradiation at heating frequency of 2450 MHz at different power levels. After successive recovery cycles the adsorption capacity was evaluated through breakthrough curves and the residue analyzed by gas chromatography. We found that exposing GAC saturated with toluene under microwave irradiation at 900W for 15 minutes can remove the pollutant from the adsorbent effectively. The recovery efficiency was more than 95% after 10 cycles at high power levels. GAC surface area and porosity values were increased slightly over recovery cycles. Our experiments indicate that GAC could be reused after several cycles of treatment and recovery processes while maintaining its original adsorption capacity and physical properties.

Keywords

Main Subjects


[1] USEPA, “Guidelines for Carcinogen Assessments” EPA 630/P,U.S.EnvironmentalProtection Agency,USA, (2005).
[2] Jin C.F., Haut M., Ducatman A., Industrial Solvents and Psychological Effects, Clin Occup Environ Med, 4, p. 597 (2004).
[3] Pohanish R.P., “Handbook of Toxic and Hazardous Chemicals and Carcinogens”, Fourth Ed., Vol. 2.Norwich,NY: Noyes Publications, William Andrew Publishing, pp. 2222-2225, (2002).
[4] Triebig G., Hallermann J., Survey of Solvent Related Chronic Encephalopathy as an Occupational Disease in European Countries, Occup Environ Med, 58, p. 571 (2001).
[5] Rutnick J.S., WittmanR.I., Neurologic Issues with Solvents, Clin Occup Environ Med, 4, p. 621 (2004).
[6] Semple S.E., Dick F., Cherrie J.W., Exposure Assessment for a Population Based Case Control Study Combining a Job Exposure Matrix with Interview Data, Scand J Work Environ Health, 30, p. 241 (2004).
[7] OSHA, “Chemical Information Manual”, OSHA Instruction CPL, 2-2.43A, (2005).
[8] Hunter P., Oyama S. T., “Control of Volatile Organic Compound Emissions”, Conventional and Emerging Technologies, John Wiley & Sons: NY, (2000).
[9] DiNardi S.R., “The Occupational Environment: Its Evaluation, Control and Management”, IHA press, Second edition, (2003).
[10] Moretti C.E., “Practical Solutions for Reducing and Controlling Volatile Organic Compounds and Hazardous Air Pollutants”, AmericanInstituteofChemical Engineers,New York, (2001).
[11] Khan  F.I.,  Ghoshal  A.k.,  Removal  of  Volatile Organic Compounds from Polluted air, J Loss  Prev. Proc. Ind., 13, p. 527 (2000).
[12] Dranca I., Lupascu Y., K. Vogelsang L., VOCs Thermal Oxidation, J. Therm. Anal., 34, p. 945 (2001).
[13] Everaert K., Baeyens J., Catalytic Combustion of Volatile Organic Compounds, J. Hazard. Mater., 109, p. 113 (2004).
[14] Sinquin G., Petit C., Libs S., Hindermann J.P., Kiennemann A., Catalytic Destruction of Chlorinated Volatile Organic Compounds (CVOCs) Reactivity, Oxidation and Hydrolysis Mechanisms, Appl.Catal. B. Environ., 27, p. 105 (2000).
[15] Wang S., Ang H.M., Tade M.O., Volatile Organic Compounds in Indoor Environment and Photocatalytic Oxidation: State of the Art, Environ. Int., 33, p. 694 (2007).
[16] Zou L., Yonggang L., Hooper C., Hub E., Removal of VOCs by Photocatalysis Process using Adsorption Enhanced TiO2-SiO2 Catalyst, Chem. Eng. Proc., 45, p. 959 (2006).
[17] Wang W., Chiang L.W., Ku, Y., Decomposition of Benzene in Air Streams by UV/TiO2 Process., J. Hazard. Mater., B101, p. 133 (2003).
[18] Hitchman L.M., Tian F., Studies of TiO2 thin Films Prepared by Chemical Vapour Deposition for Photocatalytic and Photoelectrocatalytic Degradation of 4-Chlorophenol, J. Electroanal. Chem., p. 538 (2002).
[19] Benkhedda J., Jaubert J.N., Barth D., Perrin L., Experimental and Modeled Results Describing the Desorption of Toluene onto  Activated carbons, J Chem Eng Data, 45(4), p. 650 (2000).
[20] Tiemey  M.J.,  Prasertmanukitch  S.,  Heslop  S., Removal of Toluene with Dispersed Activated Carbon, J. Environ. Eng., 132(3), p. 350 (2006).
[21] Villacanas  F.,  Pereira  M.F.  Figueiredo  J.L., Adsorption of Simple Aromatic Compounds on Activated Carbons, J. Col. Int. Sci., 293, p. 128 2006.
[22] Abril J.C., Rodenas M.A., Solano A.L., Amoras D.C., Activated Carbon for the Removal of Low Concentration Gaseous Toluene at the Semipilot Scale, Ind Eng Chem Res,48, p. 2066 (2009).
[23] Ania C.O., Parra J.B., Menendez J.A., Effect of Microwave and Conventional Regeneration on the Microprous and Mesoporous network and on the Adsorptive Capacity of Activated Carbons, Micropor. Mesopor. Mater., 87, p. 7 (2005).
[24] Chen W., Zhang J.S., Performance of Air Cleaners for Removing Multiple Volatile Organic Compounds in Indoor Air, ASHRAE Transections, 111(1), p. 1101 (2005).
[25] Jones  D.A.,  Lelyveld  T.P.,  Marvofidis  S.D., Kingman S.W., Miles N.J., Microwave Heating Applications in Environmental Engineering-a Review, Res. Cons. Recyc., 34, p. 75 (2002).
[26] Bathen, D., Physical Waves in Adsorption Technology: an Overview, Sep Purif Technol, 33, p. 163 (2003).
[27] Liu X., Yu G., Combined Effect of Microwave and Activated Carbon on the Remediation of Polychlorinated Biphenyl Contaminated Soil, J. Hazard. Mater., 147(3), p. 746 (2006).
[28] Menendez J.A., Inguanzo M., Microwave-Induced Pyrolysis of Sewage Sludge, Water Res., 36, p. 3261 (2002).
[29] Bandosz  T.J.,  “Activated  Carbon  Surfaces  in Environmental Remediation”, Interface Science and Technology Series,Elsevier,New York,(2006).
[30] Nabais  J.M.,  Carrott  P.J.M,  Menendez  J.A., Preparation and Modification of Activated Carbon Fibers by Microwave Heating, Carbon, 42, p. 1315 (2004).
[31] Guo J., Lua A.C., Preparation of Activated Carbon from Oil- Palm-Stone Chars by Microwave Induced Carbon Dioxide Activation, Carbon, 38, p. 1985 (2000).
[32] Liu X., Quan X., Bo L., Zhao Y., Chang M., Temperature Measurement of GAC and Decomposition of PCP Loaded on GAC and GAC Supported Copper Catalyst in Microwave Irradiation, Applied Catalysis, 264, p. 53 (2004).
[33] OSHA,  “Analytical  Method  and  Sampling”, Reference Method 111, OSHA, (2002).
[34] Bandosz T.J., Biggs M.j., Gubbins K.E., Hattori Y.,Liyama Y., “Thomson Chemistry and Physics of Carbons”, vol.28,Marcel &Dekker, New York, p.41, (2003).
[35] Rodenace  M.A.,  Fletcher  A.J.,  Thomas  K.M., Cazorla-Amoros D., Linares-Solano A., Competitive Adsorption of a Benzene-Toluene Mixture on Activated Carbons at Low Concentration., Carbon, 44, p. 1455 (2006).
[36] Liu X, Yu G, Han W., Granular Activated Carbon Adsorption and Microwave Regeneration for the Treatment of 2,4,5-trichlorobiphenyl in Simulated Soil- Washing Solution. J Hazard Materials, 147, p. 746 (2007).